DM-109聚羧酸早強型減水劑

特點

早強減水劑有一定的早強、減水、增強作用，屬自然養護外加劑。一般用于磚混結構建筑物所有的混凝土。摻本劑的混凝土在常溫下成型7d后可以達到設計標號的70%以上。使用摻加本劑的混凝土澆筑圈梁、構造柱、陽臺、魚蓬等構件強度增長較快。后期和正負溫度交替(日最低氣溫不低于-5℃)環境中施工的有早強要求的普通混凝土、鋼筋混凝土和預應力混凝土工程。

早強減水劑有一定的早強、減水、增強作用，屬自然養護型外加劑。本劑一般用于磚混結構建筑物所用的混凝土。摻本劑的混凝土在常溫下成型5d后可以達到設計標號的75%以上。使用摻加本劑的混凝土澆筑圈梁、構造柱、陽臺、雨蓬等構件強度增長較快，后期強度比不摻本劑的混凝土高。使用本劑既能縮短工期，又能保證工程質量。本劑適用于常溫、低溫和正負溫度交替(日最低溫度不低于-5℃)環境中施工的有早強要求的普通混凝土、鋼筋混凝土和預應力混凝土工程。

執行標準:GB 8076-2008

用量與用法

1、摻量:水泥質量的1.5%。每100kg水泥加本劑1小包(1.5kg)。

2、早強減水劑混凝土的攪拌和振搗方法，可與不摻外加劑的混凝土相同，粉劑加入攪拌機時，應先與水泥、骨料干拌后再加水，攪拌時間不得少于3min。

3、采用自然養護時，應用塑料薄膜覆蓋;低溫時，應用保溫材料覆蓋。不能用于蒸養混凝土。

四、貯運及包裝

1、塑料袋小包裝每包1.5kg，編織袋集裝大包裝。

2、本劑為粉狀。搬運時嚴防破損。貯存時應防潮。如有受潮結塊，應粉碎并通過0.63mm的篩后方可使用。

3、貯存期:3年。

早強減水劑是以 β- 萘磺酸鹽甲醛縮合物為主要成份，并復合有增強組份的高效早強減水劑，它具有對水泥品種適應性好，引氣量少等特點，減水增強效果顯著，早強作用尤為明顯，能提高混凝土抗凍性、抗?jié)B性和耐久性。產品符合混凝土外加劑國家標準。

用途及摻量:

早強減水劑對鋼筋無銹蝕作用，無毒、無污染，可應用于公路、橋染、港口碼頭，工業及民用建筑的鋼筋混凝土或預應力混凝土結構，蒸養及自然養護的預制構件等，也可用于氣溫不低于 – 5 ℃ 時的冬期施工。它的推薦量為水泥重量的 1.5% ，減水率 15% ， 3d 強度提高 100% ， 7d 強度提高 70% ， 28d 強度提高 40% ，混凝土坍落度可提高 2 ~ 3 倍，或節約水泥 10 ~ 15% 。

使用方法:

1 、高效早強減水劑為粉劑，使用時，可直接與水泥集料一起投入攪拌機進行攪拌。

2 、產品應存放于干燥處，若產品受潮結塊，應用水化開后使用。

Features.

Early strength water reducing agent has certain early strength, water reducing and enhancing effects, and is a natural curing admixture. It is generally used for all concrete of brick-concrete structure buildings. The concrete mixed with this agent can reach more than 70% of the design mark after forming at normal temperature for 7 days. The strength of components such as ring beams, structural columns, balconies and fish roofs increased rapidly when concrete was added with this agent. Ordinary concrete, reinforced concrete and prestressed concrete projects with early strength requirements are constructed in the environment of late and positive and negative temperature alternations (daily minimum temperature is not less than -5℃).

The early strength water reducing agent has certain early strength, water reducing and strengthening effects, and is a natural curing admixture. This agent is generally used for concrete used in brick-concrete structure buildings. The concrete mixed with this agent can reach more than 75% of the design mark after forming at room temperature for 5 days. The strength of ring beams, structural columns, balconies, awnings and other components cast by concrete doped with this agent increases rapidly, and the strength in the later stage is higher than that of concrete without this agent. Using this agent can not only shorten the construction period, but also ensure the quality of the project. This agent is suitable for ordinary concrete, reinforced concrete and prestressed concrete projects with early strength requirements in the environment of normal temperature, low temperature and positive and negative temperature alternations (daily minimum temperature is not less than -5℃).

Execution standard :GB 8076-2008

Dosage and usage.

1. Dosage: 1.5% of cement quality. Add 1 small packet (1.5kg) of this agent for every 100kg of cement.

2, the mixing and vibration method of early strength water-reducing agent concrete can be the same as that of concrete without admixtures. When the powder is added to the mixer, it should be dry mixed with cement and aggregate before adding water, and the mixing time should not be less than 3min.

3, the use of natural conservation, plastic film cover; At low temperatures, cover with insulation material. Cannot be used for steaming concrete.

Storage, transportation and packaging

1, plastic bag small package 1.5kg, woven bag set large packaging.

2, this agent is powder. Prevent damage during handling. Store against moisture. If there are damp clumps, they should be crushed and passed through the 0.63mm screen before use.

3. Storage period :3 years.

Early strength water reducing agent is based on β-naphthalene sulfonate formaldehyde condensation as the main component, and composite with strengthening components of efficient early strength water reducing agent, it has the characteristics of good adaptability to cement varieties, less ventilation, water reducing enhancement effect is significant, the early strength effect is particularly obvious, can improve concrete frost resistance, impermeability and durability. The products meet the national standards of concrete admixtures.

Usage and dosage:

The early strength water reducing agent has no corrosion effect on the steel bar, is non-toxic and pollution-free, and can be applied to the reinforced concrete or prestressed concrete structures of roads, Bridges, ports, industrial and civil buildings, and prefabricated components of steam and natural maintenance, etc., and can also be used for winter construction when the temperature is not less than -5 ℃. Its recommended amount is 1.5% of cement weight, 15% water reduction rate, 3d strength increased by 100%, 7d strength increased by 70%, 28d strength increased by 40%, concrete slump can be increased by 2 to 3 times, or save cement 10 to 15%.

How to use:

1, high efficiency early strength superplasticizer for powder, when used, can be directly put into the mixer with cement aggregate for mixing.

2.The product should be stored in a dry place. If the product is damp and caked, it should be used after hydration.